Here are the rod holder bases from my website that would have attached to the cleat shown in your picture. My base would accommodate T-bars or anything else you would want to attach to it.
www.ExtremeFishingConcepts.com
I have been looking for some clamp on rod holders for my Tracker, to use when trolling crank baits. Nothing I could find was wide enough for the railing. Was almost ready to design something myself when I found these on ebay. Just $19.95 each with free shipping, or buy 5 and get 1 free. Well they just came today usps and I tried them on the boat, seems like a pretty good fit. Am looking forward to trying them out. ebayer is rarnall, they were listed under rod holders.
Waterboy1
Here are the rod holder bases from my website that would have attached to the cleat shown in your picture. My base would accommodate T-bars or anything else you would want to attach to it.
www.ExtremeFishingConcepts.com
Last edited by Yadkin Guide; 01-20-2009 at 06:48 PM.
Great job on the bases!!
PROUD MEMBER OF TEAM GEEZER ---------
Ascend 133X 13' - MotorGuide Xi3 & Mercury 4
Although I like your design, I would have been limited to where my cleats are. I already have t bars for the front for spider rigging, I wanted something that I could place anywhere up or down the side, and I liked the closed bottom end so the butt of My rods can't slip out. I don't want to lose a $150 rod n reel because of wave bounce or someones wake.
Waterboy1