Driftmaster T-bar Modifaction

[crip47]

I never like how tight this was with four rods in it. Now it has a ½” bolt connector on it and a ½ “ driftmaster in the center. I haven’t use it yet but I think it will be better

[Ranger690]

Nice. Nothing better than getting things just the way you want them.

What kind of mount is holding that big Humminbird? I been thinking about a Ram mount, but don't know how they hold up. I have a small Bird on one, and the rubber seperated from the ball.

Thanks,

Dayton

[crip47]

It's a 2" universal ram mount. Holds it real nice. I've used them on the bigger lowrance units also. they've been hard to find

[creekslick]

What are the PVC crosses used for?

[crip47]

At the ramp my poles are put in there ...up & down, rigged and ready..Then when I get to my spot I just start casting..I can have eight rods out in a minute.

[gabowman]

I like the PVC rod holders. I do agree that 4 rods are tight on one T-bar. Good mod.

[Pole Bender]

I use one also and like it, you can get them from Cabela's.

[possumcop]

You need to get the 5100 gunslinger model. It is wider and your poles are not as close. My holders are made a little different also. Just look them up on their web site and you will see what I am talking about. They also make an attachment that will hold your poles upright for you instead of the pvc.

[DKR]

Nice.

[SMITTY 58D]

Crip47 what is the PVC for? is it to place the rods in when you are not using them?