Due to voltage drop in that distance I'd use 8 gauge. It's a little costly, but you won't have the current drop.JMO
Going To Mount The Old Trolling Motor Up Front On My Jon. Any One Know What Guage Wire Is Recomended. The Was Motor Used And I Never Had A Owners Manual. Battery Will Stay In Back. About A 16ft Run. I Will Never Have Over A 30 Pound Thrust On This Rig Or Foot Control. Thanks Folks.
Due to voltage drop in that distance I'd use 8 gauge. It's a little costly, but you won't have the current drop.JMO
smiles are contagious, spread them around
Proud Member of the ZIPPER Club
& Team Geezer
Use at least #8 for 16ft. If you knew the max amps it would draw you could plug the figures in here http://www.powerstream.com/Wire_Size.htm (page down). You want less then 5% voltage drop.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Thanks Folks. I Knew I Could Count On You To Know The Answer. I Also Knew It Would Be #8 Because I've Got 50' Of #10 In The Shed. As Usual I've Been Helped By The Fine Folks At Crappie.com. Thanks Again. Simpleman
I've always used 6 gauge, no matter how far the run was. Never had a problem. The boat shops around here also use 6 gauge.
GO STEELER'S!
In current carrying capability 2 runs of #10 equals #8 and saves money if you have it already.--shu
<*(((((><
be sure and solder the terminal ends on also. all that nice conductor and a crappie connection (no pun) on the end wont help you out.
I've always used 6 gauge, no matter how far the run was. Never had a problem. The boat shops around here also use 6 gauge.
be sure and solder the terminal ends on also. all that nice conductor and a crappie connection (no pun) on the end wont help you out.
I agree
Stinkies Daddy
Don't cut corners on power cables. Use good marine grade primary wire. It is UV protected. The insulation on non protected wiring will eventually break down. Then is when the troubs begin. Shorts and fires.
Yep. A lot of people ignore this advise. They pay for it sooner or later though.
Member BS Pro-Staff and Billbob Pro-Staff
Proud Member of Team Geezer... authorized by: billbob and "G"
More flexible and tinned too.Originally Posted by Cane Pole
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va