I run a 46# motorguide it uses a 40amp. I recently switched to a 40amp circuit breaker. Marine dealers have them from about 7.99-$50.00. The 7.99 works just fine and easy to install.
Hi,
First time i used my Minkota Max 55 thrust trolling motor I burn out the fuse. It was a 20 amp fuse and I'm wondering if it was the right size? Should it be a 30 amp?
Last edited by brettw; 04-10-2007 at 07:42 PM.
G3PO
I run a 46# motorguide it uses a 40amp. I recently switched to a 40amp circuit breaker. Marine dealers have them from about 7.99-$50.00. The 7.99 works just fine and easy to install.
It is not enough that a man should toil and provide,but that he be granted the pleasure of fishing with a friend.
I bought mine at radio shack.
Can't remember exactly the cost but it wasn't expensive.
Mike
Probably 40-50 amps.30 amps is too small.
Billy Deuce
Fried Crappie.... "The real thing".
Check you manual. I believe max current draw on that motor is around 45 amps so you should have a 50 amp fuse.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Minn Kota has a 60 amp resettable breaker that works real good. I think I got mine a Cabelas for bout 40 bucks. Nope. 60 amps is not over fusing. A locked (stalled) motor will draw much more than 60 amps.
Tom
Member BS Pro-Staff and Billbob Pro-Staff
Proud Member of Team Geezer... authorized by: billbob and "G"
the only circuit breaker minn kota offers to sell is a 60 amp.
thats what i purchased and hooked up to my minn kota terrova 55 lb