Sure it's not cavitation? I have an Ultrex and she runs smooth as silk, what length shaft do you run and do you long-line off the back of the boat?
I longline troll jigs for crappie at about 1.0 mph using a Minn Kota Ultrex trolling motor. After two days of solid trolling and listening to my trolling motor rattle, I really want to fix it. Sounds like there is a rattle vibration noise inside the head of the trolling motor. I can change directions and sometimes it stops. Any one else have this problem on a Ultrex or Terrova trolling motor? How did you fix it? Sure is annoying after about 16 hours of trolling!
Crappie Time
Sure it's not cavitation? I have an Ultrex and she runs smooth as silk, what length shaft do you run and do you long-line off the back of the boat?
I have the shorter 45” on my Ranger 188. I long line from the front of the boat. Never could steer from the rear. I almost hit a buoy doing that. LOL
Crappie Time
Idk but do you have a transducer cable running down the outside of the shaft? Sometimes they can make just enough vibration going through the water you think it's the motor. Add a couple zip ties if you do and maybe that will help
Sent from my SM-G900V using Crappie.com Fishing mobile app
I have the Ultrex on a ranger with smooth operation. I would suggest checking to see if your prop has been damaged. A damaged prop can cause vibration. Also take you prop off(make sure to cut power first) and check that nothing has wrapped shaft, I.e. line or weeds.
Sent from my iPad using Tapatalk
Here is a YouTube video. Now I have never done this myself so do at your own risk. Although I would like to know if others have done this with success.
YouTube
Be safe and good luck fishing
If the noise changes with steering, my guess is the mount is loose. Carefully deploy the motor while at the house and run thru the speeds briefly and listen for the vibration if it ain't there it ain't the TM.Then look under the TM for gaps. Rock it around a little. Are isolation pads installed?
Sent from my E6810 using Crappie.com Fishing mobile app
ozarks ranger thanked you for this post
I had noise sounding like gears not meshing well. Had a Minn Kota service center virtually rebuild the TM including a new control head (still will not hold better than 10’, and yes, it is the new model). They also had to replace the deploy and retrieve mechanism on my Ulterra. The techies are tremendously good, warranty is excellent but just which it would spot lock like advertised.
Sent from my iPad using Crappie.com Fishing mobile app