I use microwave for convenience. I burned a lot of plastic early on. Been messing with tubes and looking at hot pots.
Which method of heating plastics do your prefer? Microwave? Heating Pots? Hot Plates? and Why?
I use microwave for convenience. I burned a lot of plastic early on. Been messing with tubes and looking at hot pots.
Life is Good !
2018 Kentucky & Tennessee Crappie Masters State Champs!Frank300 LIKED above post
Tried everything but an injection machine. I prefer microwave. About the only thing I need to change is I need to purchase a vacuum chamber for $200 something.
Vacuum Chambers - Shop All Categories
Frank300 LIKED above postsnake River thanked you for this post
I use a M-wave to heat, and a hotplate to keep it warm
Had a steep learning curve using my M-waves, as most people have waves that are between 700 to 1000 watts
Mine are retired commercial 1400 watts So when I followed directions for heating My plastic It got burnt BAD!
Tried to heat on a hotplate a few times but always burnt a section (I'm sure operator error)
Frank300 LIKED above post
Place your plastic in it, turn on pump and pulls bubbles out of plastic. Doesn’t take long.
Frank300 LIKED above post
If one is DIY person here's a site might take interest in :
Simple DIY Vacuum Chamber and Pump: 7 Steps (with Pictures)
billygee :rolleyes: