Camo the plate before you screw it down.
Make sure nothing is under there before you screw it down.
And yeah, you gonna love em.
I just got my Millennium Spyder loc rod holders and was wondering if anyone has any advice before I screw them to the boat. I'm going to use these for pulling cranks. The catfish rod was just one I had handy. Thanks in advance.
need2befishin, Rink LIKED above post
Camo the plate before you screw it down.
Make sure nothing is under there before you screw it down.
And yeah, you gonna love em.
2018 G3 Sportsman 17
2018 Yamaha F90 four stroke
Ultra 106sv bow/console
Livescope Terrova 24v Ionic lithium batteriesRedge LIKED above post
As per above, you will love this rod holder.
i ordered extra plates, I can easily move around the boat.
great idea to paint the plates one of the camp colors, or camp them!
Sit in the seat then move holder to where it is most comfortable for you to reach. Preferably where you can grab rod and remove from holder while sitting down. Getting out of seat every time you get a bite gets old in a hurry.
Nothing to add except I love mine.
Tom
Love mine too
Crappie Time
I used a small pilot hole for the screws, also read about sitting in the seat and checking for reach
Yep, there's definitely a sweet spot between not hitting your knees and being able to reach a pole. Also, I'd make sure the trolling motor can stow and deploy without moving the rods. Made that mistake on mine.
Also, consider where you'd put another to go to 8 poles. Because you probably will! Enjoy!