Auto reset circuit breaker .... probably 50amp
Sent from my iPhone using Crappie.com Fishing mobile app
chippo
#Raymarine PRO STAFF
CHIPPO FISHING / YouTube
On positive wire for trolling motor located near battery and gas tank. I have a feeling this should be insulated. With at least electrical tape
I will probably solder in heavy duty car fuse with cap. But not sure amps yet?
Any suggestions????
Sent from my iPhone using Crappie.com
chippo
#Raymarine PRO STAFF
CHIPPO FISHING / YouTube
I used one like that in same location for 22 years.....its a automatic reseting circuit breaker.
Sent from my SAMSUNG-SM-G891A using Crappie.com Fishing mobile app
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
chippo LIKED above post
Its not a fuse, CrappiePappy is right As long as its in a protected area (no water) it’s fine. If you do tape it up, do not put tape over the reset button.
Sent from my iPhone using Crappie.com
Unless your hull is grounded to the battery, there is little danger with it dangling around.
Just for neatness I would tie it off somewhere or attach it with double sided tape.
They do make covers that fit those things, but I wrap mine with electrical tape just in case water sneaks in. I like the manual resets myself, instead of auto reset. I prefer making the choice of when it is good for reset.
Sent from my iPhone using Crappie.com
chippo LIKED above post
50 or 60 amp requirements may be different per TM brand. Mine is the manual reset, 50 amp for my MG. I have it stepped off the positive post with a $3 breaker mounting bracket I got from Grizzly
chippo LIKED above post