Another Redneck DIY crappie nibbles holder

[chadwiggins]

Used approx 3" of 1 1/2" pvc.


Mark center line, lenghtwise on both sides. Split all the way down one side. Trim approx 3/8" from both ends, leaving tabs about 1/2" in width centered on the opposite centerline.

Heat PVC until it is plyable and insert Nibbles and let cool.

Raise the Nibbles until 1/8" of PVC is below the bottom of the nibbles, heat that edge and curl under.

Clean the edges and attach to what/where ever you wish.

[mighty]

Used approx 3" of 1 1/2" pvc.


Mark center line, lenghtwise on both sides. Split all the way down one side. Trim approx 3/8" from both ends, leaving tabs about 1/2" in width centered on the opposite centerline.

Heat PVC until it is plyable and insert Nibbles and let cool.

Raise the Nibbles until 1/8" of PVC is below the bottom of the nibbles, heat that edge and curl under.

Clean the edges and attach to what/where ever you wish.

Nice diy. Thanks

Sent from my SM-J700T using Tapatalk

[ad1974]

That's a good idea.

[need2befishin]

That's using yer noggin' right there. Good job!!

[Blackjeepjk]

That's using your nibbles!

[rnvinc]

Crappie feeshermen are the most creative humans I know ...

Good job ...!!

Rickie

[RogerA]

That is a great idea, thanks for sharing.

[ShowmeCrappie]

Awesome! Been looking for that very idea but now my search is over thanks to you!!
Good job

[skiptomylu]

Slick idea!

Skip

[KokomoTerror]

Brilliant!!