PDA

View Full Version : 4 or 5 pole spider rigging rod holders that you can store in the boat.....



CHECrappie
10-03-2017, 03:48 PM
and that's also installed without drilling anything. I currently have a couple of 5 pole setups that has a brace that mounts in the seat pedestal. But to break them down and store them in the boat is a hassle deluxe! I don't always spider rig and they're in the way if I take them. Anyone make anything like this?

Erin Brewer
10-04-2017, 02:22 PM
Spider loks. Hit up EZ poleholder and check them out. They are easy to break down and can be stored in a fairly small place.

CHECrappie
10-04-2017, 03:44 PM
Spider loks. Hit up EZ poleholder and check them out. They are easy to break down and can be stored in a fairly small place.

Thanks so much for the reply!

Unless I'm missing something it looks like I'd have to mount these. That's one thing I'm trying to avoid.

Erin Brewer
10-04-2017, 04:33 PM
Yea there is a base you have to mount to the floor of your boat but it's very low profile you hardly know it's there


Sent from my iPhone using Crappie.com

Hanr3
10-04-2017, 08:33 PM
Without mounting, you are looking at clamp on rod holders.
I started with the these Tite-Lok rod holders.
Tite-Lok (http://www.basspro.com/shop/en/tite-lok-rod-holder-with-c-clamp)

cwright
10-10-2017, 02:21 PM
Extreme Fishing Concepts makes a mount that attaches to the cleats on the boat and you mount the rod holders to those. Little expensive, but no holes. Take a look at their website.

Ironman
10-12-2017, 09:01 AM
I made a bracket for the versa trac on my tracker boat. I mount millinium rod holders to them. 2 knob screws to take out and they are stored.

OCurrans
10-15-2017, 11:44 AM
I, too, have a Tracker that I would prefer not to drill holes into.
Could you show a little more of the brackets? They look sturdy - are they?
Thanks for sharing.

Sent from my Nexus 6P using Crappie.com Fishing mobile app (http://r.tapatalk.com/byo?rid=87936)

Ironman
10-16-2017, 08:17 AM
Here are some more pictures. I used 1/4 inch carriage bolts in the trac. 3x3x1/4 inch aluminum angle for bracket. It is pretty sturdy. If I had access to an aluminum welder I would add a couple gussets. I had to modify the base plate that came with the Millennium but that was easy.