Thanks: 
HaHa: 
Reply With QuoteI trimmed my old Terrova 55 shaft that I had on my crappie magnum back in 2012 or 2013, I used a saws all with a carbide blade and was very very careful to make sure I didn't cut into the wires running up thru the center.
Crappie.com 2K Star General
Anyone?
Ever shortened a Minn Kota composite shaft? If so what did you use to cut it? I need to trim off about 11 inches.
Hogsters phone
There will be days when the fishing is better than one's most optimistic forecast, others when it is far worse. Either is a gain over just staying home.
Trophy King II
I trimmed my old Terrova 55 shaft that I had on my crappie magnum back in 2012 or 2013, I used a saws all with a carbide blade and was very very careful to make sure I didn't cut into the wires running up thru the center.
Xpress H20PFC with 150 Vmax SHO
Ulterra I-pilot Link networked with Helix 10 SI Bow and Dash
SpyderLock's on the front and Tite-Lok's on the back
Creekslick Rod Holders and Millennium seats for SummerTtexastom LIKED above post
Crappie Wall Hanger II
I shortened mine up as gzrglide said be careful of wires I used a hack saw and redrilled the top hole to mount the head unit..
Crappie.com Legend
Seen some youtube videos on shorting trolling motor shafts.
https://www.youtube.com/results?sear...ng+motor+shaft
Be safe and good luck fishing
Crappie.com 2K Star General
Got it done fellas thanks for the help.
There will be days when the fishing is better than one's most optimistic forecast, others when it is far worse. Either is a gain over just staying home.
