Too expensive for this old man
Just rite tool!
Tauten Line Welder System - TWH1000ST - Tauten Sports
Member BS Pro-Staff and Billbob Pro-Staff
Proud Member of Team Geezer... authorized by: billbob and "G"
Too expensive for this old man
Well ... Whata ya know ...
Rickie
www.podunkideas.com <--Click here
------------—————
https://www.crappie-gills-n-more.com/
https://cornfieldfishinggear.com/
------------------------>> Pro Staff Sonar Advisor
The granny knot got my attention. When I first started bass fishing would tied the lures with a granny knot. A many times rare back to make a cast and the lure kept going. Lost lot of lures until I learn how to tied a good knot.
LittleJohn
fishincrazy LIKED above post
I noticed it showed for 10lb an up line weights, it must not do lighter lines?
Helicopter Pilot
Vietnam 67/68
Proud Member of the Southeast Asian War Games TeamHanr3 LIKED above post
Way out of my league and pocketbook. My fingers still work just fine.
"A voyage in search of knowledge need never abandon the spirit of adventure."
very interesting concept! dont like the over 10# part either.
If it were less expensive I might consider it if it works on Nano-Fil - love the line - hate trying to get a knot in it.
Um, that weld is huge. I bet some of us are using jigs smaller. Interesting if they found a way to apply heat without weakening the line. It might go over big with the offshore crowd if it is as strong as the best knots.