PDA

View Full Version : Spider rigging



John M
03-03-2016, 03:20 PM
Relatively new to spider rigging for crappie. Would appreciate any recommendation on portable rodholders to install on my bass boat. So that they might be removed for bass fishing. A base that secures unobtrusively, to the rear and front platforms, but your able to remove the the group of rod holders. Appreciate your recommendations on a particular make based on experience, but please refrain from making negative comments about a specific brand. Send a pm.
Tightlines
John

vic n
03-03-2016, 03:51 PM
I think all of the rod holders have removable uprights and the base piece is usually pretty flat. Check in the "member/sponsor forum" because some of our members make good products

Cray
03-03-2016, 04:07 PM
Check out the SpiderLock holders. They have a flat base plate attached to the floor. Never know they are there.

fishervet
03-03-2016, 04:40 PM
Check out the SpiderLock holders. They have a flat base plate attached to the floor. Never know they are there.is that ezpoleholder?

Cray
03-03-2016, 05:40 PM
is that ezpoleholder?

Yes.

CrappiePappy
03-03-2016, 05:47 PM
"Vic n" is correct ... most T-bar style rod holders screw into a low profile base plate. You've got plenty of choices on brand & style, and price ranges. You can also pick up a used set on the Personal Classifieds forum, every now & again.

I use the Hi-tek Elite 4rod holder systems on my 16' ProCraft, and like them just fine.

... cp :kewl

fishervet
03-04-2016, 10:42 AM
spiderlocks are great.

trypman1
03-04-2016, 10:45 AM
Hi-Tek for me, but any will do.

TomTom1
03-04-2016, 11:36 AM
Drift masters has a flat base plate,

shadboy
03-04-2016, 06:43 PM
Ed Dukes, at Southern Crappie Rods ( Home - Southern Crappie Rods (http://www.southerncrappierods.com/)), sells a really nice fully adjustable t-bar setup.

Tony the Tiger
03-05-2016, 08:46 AM
I like my Hi Tec.s

John M
03-14-2016, 05:03 AM
Well, have finally taken the plunge. Set up my bassboat for spider rigging and trolling Erie for walleye. But have found an alternative form of rod holders that install around your boat cleat. The can't be installed and removed in a matter of seconds. Found at welded crafts website. Special order for your particular cleat size and angle of installation on your boat.
Really looking forward to adding pushing and pulling, trolling( small outriggers) to my arsenal of presentations to crappies.