PDA

View Full Version : wally marshall rod help



speck chaser
12-15-2006, 08:06 PM
does any one know if you can get replacement ends for the wally marshall signature series two piece rod i broke one this weekend my fault totally it is a 10' rod. it is broke down too far to just replace the tip.

abarkley
12-15-2006, 08:43 PM
unless they've changed i dont think you can. i broke mine close enough to the end to cut it down to the next eye.

PanMan_VA
12-15-2006, 10:51 PM
I don't think they sell tips. I have broken 3-4 inches off a couple of my WM rods (my fault), and was able to remove a guide and put a new tip on.

birdman
12-15-2006, 10:57 PM
i know that for a fact atleast in illinois that if you save your receit on the new WM when one breaks, you can send the broken one in with the receit and get a new one...as long as its in the 1-year warrenty

JohnR
12-16-2006, 09:06 AM
I broke my new 12' Wally Sig Series right above the middle joint, and wasn't even applying much pressure. Didn't really want to replace it with the same, Lost faith in it. Replaced it with a 12' BnM BrushCutter, so far so good. I've had a 10' BrushCutter for 3 years and it's been through everything and proven itself as a good rod. Hoping the 12' will be just as good. The plain (cheap) BnM jig poles don't seem to hold up good for me either. The BrushCutter model is a little heavier duty, but you may have to order it, WallyMart don't seem to carry it.