Go to the Mississippi board and check out pulling cranks 101 what works there will work up here best place for info on pulling.
Anyone on here pull cranks around the linn creek area or on pomme? Just getting in to cranking would like to get some much needed help.
Go to the Mississippi board and check out pulling cranks 101 what works there will work up here best place for info on pulling.
Balzout Mounts
Put a bandit 300 in the water let out 60-70 feet of line in linn creek cove and go bout 1.7 mph. That'll get u started.
"Put a bandit 300 in the water let out 60-70 feet of line in linn creek cove and go bout 1.7 mph. That'll get u started."
x2 plenty of fish in the linn creek area, gets better as it gets hotter
I have ran cranks before but I'm used to running smaller coves with less docks. I usually run 20-30 ft of water. I'm not having much luck at these 2 places doing my normal stuff. I'm running 6 rods with bandit 300s and flicker shads. I haven't tried the linn creek cove but will start. Thx for the help.
Cool! Good job!
Good work!, end up goin to the Linn Creek area?
Dadgum nice work!! See u got it done with the G3 1860. Got the same set up. Congrats. Smile on the little guy says it all
Yeah. Caught majority on cranks. My kid said he wanted to fish jigs so we tried a couple docks. I caught about 6 before he caught one. I tried to get him to go back to cranks but he was getting mad. Said we weren't leaving until he caught one. Ha ha. We had 22 when we left the dock. Went back to cranks ended up with 38 crappie and one walleye between 3 of us. Thx for the help.