rod holder brackets

[Iron Man]

I made these rod holder brackets out of necessity and a low budget. They fit the top rail of a War Eagle (Duracraft).Attachment 121966

[Iron Man]

oops, I must have done something wrong. More later.

[Iron Man]

This may or may not be helpful.

[Stev]

Sweet dood .
I like the slide rail you did with them .

[Iron Man]

thanks

[Stev]

Nice clean job .no sharp edges .

[skeetbum]

Good idea. They would be much better if you had them powder coated, and wouldn't stain the boat. Good job.

[T.C.]

looks good

[Eagle 1]

would like to have 6 , these were made by war eagle , but no adjustment up and down . they could make a ton on accessories . you can see one beside the trolling motor . I use two , the other one not seen in picture . would be awesome if they would tilt .

[Cray]

Those are nice. Assume from you handle you have access to cutters and benders. That is nice bend in the bottom section.