The ones I use to have were made out of plexiglass.
Tryin to figure out what to use. This boat has two huge livewells and there are grooves to put 2 dividers in each livewell. What would you guys use? I thought about some old campaign signs and cut some fair size holes in them, but dont know if that would work or not. I am sure some of you guys have constructed something.
The ones I use to have were made out of plexiglass.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Polycarbonate would be better, can't break it!
Proud Member of Team Geezer!
Hmmm i may try that, what size holes would you put in it? Several small holes or a few large 1-1/2 holes
Mine are plastic also!
You might try HDPE (High Density Polyethelyne), the stuff cutting boards are made of. I have pieces as this as 1/16" and as thick as 3/4". The 1/16" with 8-10 3/4" holes spresd out should do the trick.
Use small holes. They also help keep water from sloshing back and forth.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
I made one out of a plastic cutting board from wal-mart. Drilled some 1" holes in it. Works great
A person should learn something new every day!
What they said. All good so far.
Creativity is just intelligence fooling around
What if you put 1/8" holes lots of them and now you also have a baitwell. Or even 1/4" holes. just small enough for the minnows to stay where they are at.