Atwood rod holders ?

[SteveJ]

At least I think they are Atwoods, the ones at Wal-mart. They only have the flat angles here and I was wondering if anyone had tried to bend them up to a different angle? May have to order a couple.

[J White]

Hey Steve, I've got six of those I might could make you a deal on if you
want, I used them about twice during my experiments with tight-lining:rolleyes: They are mounted on a 1x2" aluminum rectangle tubing
six feet long. I did move a couple of them by bending, just to make all of
the rods sit the same, only bent them maybe 1/8" or so. They are pretty tough to bend, but it did ok.

[SteveJ]

I got 4 that I have mounted on the sides of my boat, all 4 are the 0 degrees kind. When I started CB trolling I figured it would be better if 2 of them were say 25 degrees or so to kind of keep my lines apart a little better. I built up the front and back of 2 of them and got a little beter elevation on my rods. I only need 2, really don't need them I guess, but thanks for the thought. Put them on the swap board. Are you trolling any, wife had surgery Tuesday and was in for 2 nights so I haven't been able to go, looks like we may get a break in the heat next week and I may be able to go.

[J White]

Not since last weekend, I'm in the middle of trying to trade boats and
can't sleep, no appetite, headaches :D in love (or lust) or something like
that. But maybe I'll get loose tomorrow for awhile. Best wishes and
"get well soon" to the better half, Jeff

[gabowman]

The will bend but it would require a vice. You may also consider mounting them on some sort of a pipe so they can be adjusted at any angle you like 'em at. Here's mine:

[Rowdy]

WE fine tune ours all the time, Use a pipe or stong broom handel.

Rowdy