Even newer TM Brace from E-Z

[E-Z Poleholder]

Here is what you get


Here is is put together


Here is the buckle system in lock position


Here it is unbuckled


Here is the TM shaft protecting pad


This new TM brace is adjustable from 6 inches to 24 inches and has a very nice and easy to use 1 inch strap.
Locate where you want to install the TM Brace and use the supplied selftapping screw to afix it to your boat with the
strap under the milled aluminum base as shown in the pic above. If the pipe is not the correct length, cut it to fit and then
simply place it under your TM shaft, bring the strap and buckle over the shaft, hook it as shown in above pic, and tighten.
When you have it installed at the desired height, simply cut off any excess strap, but not too much where you can't get
ahold of it to tighten it. Use a lighter, or such to seal the end of the strap so it won't unravel. Cut it at an angle,
like it comes, to make insertion into the buckle easier.

Specify the height and I will cut the pipe and strap to fit.

$29.99 plus shipping...

[E-Z Poleholder]

The above pics show a simulated TM shaft.
Here is one just showing the pad for the shaft.


And one of the TM Brace installed

[satdoc1]

EZ, are you coming to fall camp at Sardis this year? If you are bring a few with ya and I will gurantee at least ONE will be sold.

[E-Z Poleholder]

EZ, are you coming to fall camp at Sardis this year? If you are bring a few with ya and I will gurantee at least ONE will be sold.

Man I hate to say it, but I can't make it.

I am, however, putting one up for a prize. Maybe I should send a couple with my top salesman...

[satdoc1]

If ya talkin bout "G" or the Maj, I know that at least one will be sold.

[wilbur]

Hes gotta be talkin about WB. You know all salesman have a line of sh...... and Wb has the longest.

[satdoc1]

EZ aint crazy enough to trust WB with em cause he would loose one for sure. And in a few days it would MAGICLY appear on his boat!