My shipmates on iBoats seem to like them. Its pretty rare to see any complaints about them.
I fount the golden egg Easter egg huntin'. So, I been looking at the CMC PT35 for to purchase. It is a real strain to lift the 15hp 4 stroke. Opinions????
Member BS Pro-Staff and Billbob Pro-Staff
Proud Member of Team Geezer... authorized by: billbob and "G"
My shipmates on iBoats seem to like them. Its pretty rare to see any complaints about them.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
i liked the one i had on my 50hp evenrude,i think if ur motor is a clamp on u have to buy an optional bracket though
I just replaced my tilt n trim motor and reservoir on my 75 hp Force motor. I went thru iboats.com and was very happy with the service that I got thru them. They will give you several options with which to go and will take them back and exchange them if they don't work. EB
DO-GOODER EXTRADINAR :p
They work well, I drilled holes in the pt and also clamped the top side.
HOOKED-FISHING.COM CDC PROUD SPONSOR
B'n'M Pro Staff
Bobby Garland Crappie Baits Pro Staff
Outdoor Writer
Get it CP I have a unit made for a couple of years by Minkota with a40 mariner on it. Have used it for 12 or so yearsonlyway to go. If I was doing it over would have gone with CMC unit. Heavier made. Like Sparkie sad I mounted mine and drilled holes and used stainless bolts with nylon nuts. You will find the setback also gives a little more lift and speed.
Proud Member of Team Geezer
Charlie Weaver USN/ENC 1965-1979
hmmm thanks CP, I have been strugglin with lifting my motor and lettin it down because you have to put your fingers right in the slot where the motor comes down and I am very scared of the motor slipping and I know it would break my fingers ifn it didnt take them off. didnt really know that they made these for small motors.
maachuu