Long line rod help

[markd85]

Hi All
What would be the best choice in a 14' rod for long line trolling? I will be using 1/32 up to 1/4 oz. jigs. Thanks.
Mark

[stumpjumper]

I"ve own several different types, Southern crappie rods, B'nM's, Outlaws, all work well, If you not already trolling then you'll need several different length poles to spread your jigs out. I pull (14) rods out the back of my boat from 14' down to 5'6". 7 rods on each side of the motor they drop in length in 2' intervals until I get to 6' then I turn them to make the inside spread work.

[GCD]

Folks on here really seem to like the B&M poles, but I've never used one.

I did pick up 3 BassPro Wally Marshall Signature series last week and really like the looks and feel of them... it'll be better when I get to use them.:rolleyes:

[Hitek]

I like the B&M Prostaff Trolling rod for long lining. The Wally Marshalls are a little stiffer which I do not like for long lining. I do use the Wally's for trolling crankbaits, they work great for this.

[markd85]

Thanks everybody
I was lookin at the b n M pro Staffs but thought maybe they were more for pulling cranks? Are they limber enough for 1/32 oz. jigs? It's tough to buy a rod without getting it in your hand.

[bchappell]

We use BnM prostaff 14 to long line with. They are a little stiff but they do just fine.

[drill instructor]

BnM Buck Graphite jig poles is what im been using for years long lining. I prefer using the prostaff rods for cranks.

[skiptomylu]

I guess the model of the rod at B&M makes a big difference because I have a 10' & 12' Wally rod; also have 3 B&M Buck's Ultimate and the B&M's have more back bone than the WM's. I like them all though and especially like my rod's I got from member here, The Lip RIPPERS.

I use my 10' rods for long lining and don't have any longer than 12', but maybe would if I did more pushing jigs.

Skip

[Cajun_in_GA]

I just ordered 8 Capps and Coleman Trolling Rods this morning. 14 foot

My understanding is the BNM Pro Staff Trolling Rods will work better for crankbaits etc.

I have read this on the web and spoke with BNM as well.

[Bartman]

I just started long lining and didn't want to invest a lot. I picked up some 10' & 12' telescoping rods at Miejer. They are made by Hi-Teck (I don't think it's the same company that makes the rod holders) and and you can install a spinning rod on them. They are black and green and do a fine job for me. The 12' was $9.00 and the 10' was $8.00. I run 12', 10' and 8' out the sides and 6'-6" spread out across the back. I have $18 invested in each complete pole ($9 rod, $7 reel and 3000' of hi-vis vicious for $10)