Tip #1....DO NOT do it on your driveway !!!!!!!!!!!!!!!!
P
Need Help On What To Use To Clean Carbon Out Of 2 Cycle Outboard Engine.want To Direct Inject Cleaner Through Air Intake On Carbs.would Appericate Any Suggestions.
JERK THEM OUT BY DA ROOTS!!!!!!!!!!!!
Tip #1....DO NOT do it on your driveway !!!!!!!!!!!!!!!!
P
Get a can of Deep Creep (Autozone or Napa) and follow the instructions. Like Piroque said, do not do it on your drive way, it makes a mess. If you need to do a thorough job here are the instructions.:http://www.iboats.com/cgi-bin/ubb/ul...;f=36;t=000006
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Hey Ibnfshn, Good information, Thanks for sharing. Jimmy S.
seafom is highley recomended by mos outbord forums like.
http://www.themarinedoctor.com/cgi-bin/YaBB.pl
do a serch on decarbing.
retired and now i will always fish
This place has step by step instructions for outboard motors.
http://www.boatsetup.com/
Ted
Neither snow nor rain nor heat nor gloom of night will keep me from crappie fishing!
2010 Lake of the Ozarks Super Slab Champion
SeaFoam is about the best there is to clean out carbon. Used on old outboard had and then the other day truck mechanic recommended using it on the truck.
Thanks For All The Good Info Will Try To Put It To Good Use.going To Get Some Deep Creep Tomorrow.
JERK THEM OUT BY DA ROOTS!!!!!!!!!!!!
I did this last fall....run your motor with the ear muffs on for about 10 minutes at idle just to get it warm. spray the Sea Foam into the intake a little at a time. you'll need to work the throttle to keep the motor running. Once it starts to smoke really good , like a mosiguito fogger, shut the engine off and let it sit until it's cool again. Repeat this until you use the whole can. The next time you put the boat in the water you will still get a lot of smoke but that's just the rest of the carbon burning off. I got this method from www.iboats.com forums.
Scott
Sea Foam.... If it doesn't work.... you'll need tools.