Lantern hanger

[INGrandad]

I'd like to be able to hang a lantern like I used to over the side of the boat. Necessary? No, just something about the smell of burning bugs that I missed the last couple of times out. What do you guys use? I did some googling, no results.

[guest01]

B&M make one for around 18 bucks

[hunt4crappie]

Check out this link. Is this what you are looking for?

Lantern Holder

[Len]

I made this one using 1-1/2" metal conduit and a 90 degree PVC conduit. The pedestal floor mount holds it.It can swing it to either side of boat.

[Yadkin Guide]

Check out Driftmaster's Lantern Holder on my website. Scroll to the bottom of the page. Here is the link.

Driftmaster Rod Holders

Yadkin Guide

[boat49]

I like that Len. Is that just 2 pieces of conduit screwed to the 90 or is the piece coming up from the floor mount attached to something? I think even I could make something close to that!!

[Len]

I like that Len. Is that just 2 pieces of conduit screwed to the 90 or is the piece coming up from the floor mount attached to something? I think even I could make something close to that!!

Yes that is two pieces of conduit bolted in the ends of the PVC. The piece coming from the floor is a piece of galvanized fence post because it was a tighter fit in the floor opening and the 1-1/2" conduit fit inside perfect.The brace under the 90" elbow is 15" inches of 1/2" conduit and the brace that is bolted onto the lantern shield to keep lantern from swaying is 3/4" inch flat aluminum 17" long.

[crappiepastor]

Check out www.crappiekiller.com for an alternative that looks pretty good.

[speckfinder]

I made this one using 1-1/2" metal conduit and a 90 degree PVC conduit. The pedestal floor mount holds it.It can swing it to either side of boat.

that's a good lookin rig

[INGrandad]

Yeah, I kind of like that too.