Search:

I don’t think there’s ever a concentration of fish around there, although I’d like to hear what others have to say. I’ve caught some walking up and down the docks.

Didn’t fish any this spring due to house projects. Now I’m learning Rebmans and Decatur Bait and Tackle for live minnows in Decatur have closed. Any others available nearby to anyone’s knowledge?...

Fished Flint this morning. Crappie, stripe, and cats on minnows. Crappie scattered in 5-10 fow. WT was 68 when i started. Kept 5, largest was 13". 250612

Thanks!

Hey thanks, Ernie has worked on my motor over at Bud's. I would like to have his contact info. You can text me at 256 565 4848.

Thanks Spiderman. That would be a long haul for me as I live in Decatur, AL.

Looking for a reliable motor mechanic in the Decatur area. No problems at the moment, but I'm sure I'll need someone in the future. My previous mechanic closed his shop here. Thanks for any...

Anyone know of a reliable motor mechanic in the Decatur area? Not having any problems at the moment, but I will sooner or later. Bud Payme closed his shop in Decatur. Thanks for any suggestions.
...

Johnson Seahorse 12V. Bow mount, foot control. Has 3 position switch, but only runs in low and medium. I believe it's 28lb. Asking $40.

willow flies were out last Tuesday in Decatur

thx guys. there's fish to be had around here especially in he backwaters. I juwt haven't found my way in there with my boat and I don't kayak.

Fished the causeway bridge
with minnows, no luck. Had 1 cat along the causeway, full of eggs. No pic, I ate her for lunch.

Nice fish. Thanks.

yeah, if they're the same diameter they should go in. Clean up the mating surfaces good. May be a burr somewhere.

I was speaking of the inside diameter of the hub body, either where the bearing cone is pressed in, or where your bearing buddy presses in.

Actually I was in 12' of open water. Just got lucky.

I just bought 3 BnMs off eBay from Grizzly Jig for $127 including shipping.

If bearings aren't rusted or pitted you can reuse them. Just clean and repack. Replace seals. Use a micrometer or calipers to check your axle diameter and hub ID for bearing size.

Your welcome FC. Thanks again and nice to meet you!

Sold, thanks.

I have four Firecast 122s for sale. These are mostly fiberglass construction. Used less than a year. $40 for all 4.

Near Ingalls harbor Bob, chat/grn road runner with b/g bluegrass.

237749
Finally got one this windy afternoon, but she was a good un. That cutting board is 14 in. long.

yeah, I didn't catch a crappie in Flint deep or shallow. Had a few stripe and gills plus a nice cat. Couldn't keep the big gar off my hooks.

Stained, but not muddy. Fish on the graph in 5.5 FOW, but couldn't get any notes on minnows.

Zilch on Flint this morning. The guys ahead of me at the ramp must've went to Limestone.

RISEN INDEED!

sounds like a fun day! don't get caught in possession of all those 8 inchers!

Went back to Flint this afternoon with the wife and we boated 10 in about 3 hrs. Lost 3 or 4 and one short one. A couple 14 inchers. All on minners in 3-5 FOW. WT 67 deg.
232777232779

I really didn't pay any attention to boat registrations. I guess there could have been some from out of state. I didn't have any problems with anyone, in fact, everyone I came close to was friendly....