+ Reply to Thread
Results 1 to 4 of 4

Thread: mercury 150 xr6

  1. #1
    keith dodd's Avatar
    keith dodd is offline Crappie Wall Hanger II
    Join Date
    Jun 2005
    Location
    Madison,al
    Posts
    615

    Default mercury 150 xr6

    Sometimes when I take off the egine stall like it is running out of fuel I let off throttle and go again and it does fine. what could be causing this? thanks in advance

  2. #2
    The Marine Doctor is offline Slabmaster
    Join Date
    Apr 2007
    Posts
    59

    Default

    The engine is running lean at idle and stumbles to find fuel.

    Check and clean your fuel system.

    TMD

  3. #3
    Darrell Baker is offline Slabmaster II
    Join Date
    Dec 2006
    Location
    Centre, Alabama
    Posts
    176

    Default

    Keith,
    What model is your motor? I have a 1994 Mercury 175 and I had never had a problem. Recently my motor was doing the same thing. It would idle and come out of the hole great but usually after just a short distance it would start losing power. It would not sit down completely with me but if I was going 45 mph it would start slowing down to about 25-30. I carried it to a great mechanic today and he checked the motor from top to bottom. The regulators, stator, power packs, fuel system etc. all tested great. It turned out to be the oil-injection system. It was not oiling enough and so the computer was getting this reading and would start to cut the power back to reduce the risk of damage. I had been told by several mechanics in the past that after a motor gets several years old you need to unhook the oiling system anyway and mix your gas/oil manually. Just to make sure it is getting the proper mixture. The alarm was not going off because it was getting some oil but just not enough. It is a pretty cheap fix compared to buying a new motor. I put it in the water today and it is running great! This may not be your problem but if it is an older motor I would have this checked...See Ya on the Water!

    Darrell Baker
    Weiss Lake Crappie Guides
    PO Box 778
    Centre, Alabama 35960
    Tele/ 256-927-2232
    Cell/ 256-557-0129
    weiss lake crappie guides




  4. #4
    Join Date
    Jul 2009
    Posts
    1

    Default

    keith, i have an 01' xr6 that was doin the same thing.turns out my problem was just the primer bulb. apperently the insides of the bulb fizzled out and it just needed a new one. now it runs great starts good,but im haveing overheating problems at low rpms and idle.did impellar and now tryin t stats.

+ Reply to Thread

Similar Threads

  1. Mercury 200
    By AUTiger in forum Mechanics Corner - boats, motors and trailers
    Replies: 1
    Last Post: 11-13-2010, 07:06 AM
  2. Old Mercury help
    By Mud Dawber in forum North Carolina
    Replies: 15
    Last Post: 05-05-2009, 08:03 PM
  3. mercury not mercury
    By robbor in forum Off Topic Forum
    Replies: 9
    Last Post: 12-12-2008, 06:58 PM
  4. 75 hp mercury ?
    By pstone in forum Main Crappie Fishing Forum
    Replies: 21
    Last Post: 06-08-2007, 12:25 PM
  5. Need Help On Mercury 150
    By TOMMY4UA in forum Main Crappie Fishing Forum
    Replies: 15
    Last Post: 03-04-2006, 09:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts