LinkBack URL
About LinkBacks
Reply With QuoteI spliced one and sealed it with silicone it worked ok for a while but i eventually had to replace it.
Trophy King II
Transducer wiring???
was wandering if it is possible to splice the wiring for a transducer, mine came loose and got pinched on the trailer. Before I found where it was shorted out it would kill my motor in a heartbeat
Moderator MO Forum
and Member Sponsor
I spliced one and sealed it with silicone it worked ok for a while but i eventually had to replace it.
For a full line of Ozark Rod's,fluid beds
soft plastic, jig heads and more see us at
www.simplycrappie.com
http://stores.ebay.com/Simply-Crappie
Crappie.com 1K Star General
If you are talking power wiring probably no problem. If you are talking tranducer signal wiring, be very carefull you do not shorten. It would probably be best to bite the bullet and replace with new.
Happiness is a belt fed weapon.
Some people have heroes that wear capes.
MY heroes wear kevlar vests embossed with the Eagle, Globe and Anchor
Super Moderator
Crappie.com Supporter
If its a Lowrance or Eagle, you can get a repair kit for it.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Crappie.com 1K Star General
Crappie.com Supporter
They aren't too bad to splice. Solder the insulated conductor(s) and seal the joint with liquid electrical tape and heat shrink tubing. Then solder the shield, and seal the whole joint with silicon and heat shrink. The slight impedance change caused by the repair won't have much impact on the performance.
Posting Permissions
