Hi-Tek Rod Holders

[callshy]

Thanks Scott. My Ranger rails are the old type. One piece of straight, hollow aluminum tube, with a mount at each end and two supports. So it looks like three sections. Only pop riveted in the end mounts. I can easily drill the rivets, slide out the tube, slide on your normal mount and reattach with a stainless sheetmetal screw where the rivet was. So I can use your normal mount, unless you has a super snazzy two piece design.



The Ranger rail mics .875 and the driftmaster tube mics .882.

Have you ever considered as an option to have a short piece of rod tacked to the main mount bolt to allow adjustment without a wrench?

I will drop you an email.

Dayton

See photo for two piece clamp design to fit on mounted rails.

[Ranger690]

My wife just told me she feels bad that she doesn't have me much for Christmas. Hummmmmmm.....Scott, you may be getting a note from me soon!

Thanks,

Dayton

[callshy]

My wife just told me she feels bad that she doesn't have me much for Christmas. Hummmmmmm.....Scott, you may be getting a note from me soon!

Thanks,

Dayton

Just let me know what I can do for ya!!

[CrappieKillerJigs]

hey scott i got a ?....just asking this since i see you can custom make your product..how hard would it be for you to weld a 3/4in pin on the bottom of the upright so i can slap it in one of my drop ins....if you can do this then i will need to order 4 up rights with cross bars and 16 holders....

[callshy]

hey scott i got a ?....just asking this since i see you can custom make your product..how hard would it be for you to weld a 3/4in pin on the bottom of the upright so i can slap it in one of my drop ins....if you can do this then i will need to order 4 up rights with cross bars and 16 holders....

Should not be that big of a problem. Do you need the 3/4" pin threaded? Give me a call and we can discuss (256-616-9934).

[Ranger690]

Scott, I placed an order yesterday. What are the threads tapped into the actual rod holder. I'm making some pieces at work and want to drill some today.

thanks,

Dayton

[CrapSlabStu]

This thread is keeping you busy Scott. But if nothing else it demonstrates the pride and support you show for your product. Impressive stuff in today’s world sir, and sometimes it’s that show of support that can sway a customer.

Been looking at investing into a holder system for months........... Afraid to pull the trigger........my money comes hard earned as I’m sure most folks around here are the same.

Once I found this thread, the decision became extremely clear, through your efforts I choose to support HI TEK.

Ordered 2 sets a few nights ago, and I’m feeling like a happy camper.

I hope I never have any issues concerning any of my purchased fishing equipment, boat, etc. but it’s a nice piece of mind knowing if something does happen, Ill be dealing with fine folks on the other end

for some..... knowing that becomes a serious bonus.

Keep up the fine efforts sir.................. word of mouth is priceless, and Crappie.com is a great source of information for this ole redneck fisherman :D

God Bless The USA !!!

Stuart Levine
Clermont Florida

[1Caprandy]

Sweet