Thread: ok all you boat guru's ??

does anyone know where or if I can get the transom brace for my starcraft. I would like to replace the one on there now and I am not haveing any luck finding ANYTHING.

Dont mean to sound stupid, but have you checked with a dealer?

Try this
http://cgi.ebay.com/ebaymotors/Trans...spagenameZWD1V

crappieday, send me sketch and I'll make you one. Need measurements and angles. Do you have my address or email address?

Originally Posted by trumpdriver

Try this
http://cgi.ebay.com/ebaymotors/Trans...spagenameZWD1V

the piece I am looking for is like the ones on the inside or the transom on jonboats. its a thin aluminum brace in the center of the transom going down to the floor to strenghten the center of the transom

Originally Posted by willsjwills

crappieday, send me sketch and I'll make you one. Need measurements and angles. Do you have my address or email address?

I think I have your email but not your address. I will take some mesurements, pics and measurements again.lol and send them to ya tomorrow.

here is one more like what you are looking for
http://www.theshadconnection.com/cgi...e.cgi?page=206

Originally Posted by trumpdriver

here is one more like what you are looking for
http://www.theshadconnection.com/cgi...e.cgi?page=206

That may help but here is a pic of the piece. do you think it would be a replacement fot it. and THANK YOU for looking for me:D

The tp32 looks like what you have now. The tp30 is 14 inches high. Tou may have to trim around the braces that run from the floor up to the transom. I think if you remove the motor and install the tp30 long bracket on the inside and the short one on the out side and seal it with silicone then remount the motor you will be fine. Especially with the supports from the bottom of the boat rib to the transom. You might still want to call these guys tomorrow and double check the measurements. They might have another type not listed on the web.

I will give em a call tomorrow but I think your right it looks like it would work. Thanks for all your help man. got the boat back today haveing a honda 50 put on and trying to get it all rigged back up. The wife and I are planning on coming to a slabfest soon.