My 332 would always read 1.7 when my motor was out of the water. Don't know what the problem is, just thought this might help figure the problem out.
I acquired a lms 332c unit and a x125. I was gonna put the 332 on a small boat i have. They had one transducer with them when i got them and not sure of the model transducer. The x125 works fine but the 332 does not read a depth it usually flashes 1.7 ft the whole time its on, water temp works. My research shows that they will operate off the same transducer. Can anyone tell me what my problem could be? Hate to invest much in old unit but would love to have it working.
My 332 would always read 1.7 when my motor was out of the water. Don't know what the problem is, just thought this might help figure the problem out.
Thanks for the reply. I guess 1.7 must be the magic number when its not reading a depth then. Any other suggestions?
#1 - contact Lowrance Customer Service
#2 - post question on Electronics forum
#3 - weigh the cost difference between a new transducer & a new unit
... cp
1. I contacted customer service and was told that they no longer service those units.
2. I figured this might get more views on the main forum
3. I am basically wanting this unit on a second boat that is not used all the time. If i could find a way to get it working it would be great but not gonna invest in new unit for sure. Just wondered if anyone else had run across similar issues